User manual

EN-28
10. ProjectorView (ProjectorView enabled projectors only)
ProjectorView is a web-browser based remote control and monitoring tool for network projectors. If you use the
projectors listed on page 30, see ProjectorView in “LAN Control Utility” User Manual included with the projector.
10.1. Starting ProjectorView
(1) Select the projector that you want to operate from the list of projectors on the main screen.
• StartProjectorViewforoneprojectoratatime.YoucannotconcurrentlyuseProjectorViewformultiple
projectors.
(2) Click [ProjectorView] in the tool bar on the main screen.
• TheWebbrowserlaunchesautomatically.Thepasswordentrywindowisthendisplayed.
<Note>
• YoucanstartProjectorViewbymanuallytypingtheprojectorIPaddressinyourwebbrowser’saddress
bar.
• Ifyouareusingaproxyserver,donotenableproxysettingswhenaccessingtheprojectorIPaddress.
• UptothreeProjectorViewunitscanbeusedtocontrolasingleprojector.
(3) Enter the password and click [OK]. (The default password is “admin”.)
• “ProjectorView”mainwindowisdisplayed.
<Note>
• Theconnectionwillturnoffinveminutesafterthepasswordentrywindowisdisplayed.Youcannotenter
the password then. If this happens, restart the ProjectorView.