Setup guide

€ Using the Active AN Network Feature
_>Important:
_>Important:
_>Important:
DImportant:
The A/V Network is a special feature that makes it easier to use
your Projection TV and your other Mitsubi,_hi A/V components
together. When you connect the A/V Network, you can point the
remote control at the Projection TV, and it will "pass" the remote
control command to the other components.
Additionally, if you have a Mitsubishi VCR with Active APV"Net-
work, it is easier and faster VCR's play command (Auto Play).
The A/V Network is only available for select Mitsubishi
components. If you subscribe to StarSight, ':'Auto Play" is not
available.
before you begin
You must have connected an A/V Network cable from the Active
A/V Network terminal of your Projection l.W to the A/V Network
IN terminal of your VCR. See Booklet #1, "Mitsubishi
Installation and Setup Guide."
J You must have connected your VCR to Input 1 of your TV.
J You must have set your Projection TV's "._JV Network" setting
to "Active" or "Basic." See "Setting the ._dV Network," page 32.
J Your VCR's remote control switch should 5e set to '_CR-A."
J Your VCR's video mute setting should be _urned ON.
When using the Active A/V Network, you shoald always point your
remote control at your Projection TV.
Using Auto Play
When you press PLAY on the remote:
•/ Active A/V Network will turn your VCR on and begin playing
the tape (if any).
J Active A/V Network will turn your TV on and switch it to
INPUT-1.
When you turn your Projection TV off:
€" If your TV has been set to "Active," your VCR will turn off,
unless it is playing or recording.
If you leave the Projection TV turned on and:
- it is set to Input-l, and
- it does not receive a signal for five minutes, and
- you do not use the menus for five minutes, then:
the TV will automatically turn off.
If you turn the TV off while it, is set to Input-1, it will return to its
previous antenna and channel setting when you turn it back on.
Using the Active A/V Network Feature 75