Setup guide

Changing the picture in the PIP image
When you first activate the PIP image, as described on the previous
page, you will probably see the same picture in the small image as
you do on the main image. This is because both images have the
same "source." A "source" is any signal that your TV is receiving
through the antenna terminals or through the input terminals.
If you want to see a different picture in the PIP image, you need to
change its channel or change its source.
changing the channels of the
PIP image
Because your Projection TV offers
"two-tuner" PIP, you do not need
to change sources to view a differ-
ent channel in the PIP image.
O Make sure Antenna A is the
source for ygur PIP image.
O Press the small PIP channel
button (CI-L_qNEL) on the
lower half of your remote to
change tl_e channel of the PIP
image.
DImportant: To use the "two-tuner" PIP, you :must have made a connection to
the Antenna A terminal on your Projection TV.
68 Chapter 3: Using the Special Features