Setup guide

_Important:
Setting the timer
This special feature allows you to program the Projection TV to
turn on automatically at a time that you set. To set the timer:
[] MAIN MENU
_ irst Time Setup
Customize Display
Advanced Features
StarSight Setup
Use these buttons on the remote:
E_]ADJUST [] ENTER I'_ MENU tO
tO select to enter go back
O Press the MENU button on the
remote control. The Main Menu
will appear on the screen.
Use the ADJUST buttons to
select "Advanced Featur_,s.
Press ENTER.
[] ADVANCED FEATURES
[] Set the Timer
[] Use Parental Lock
[] Set SuperQuickView
[] Use Advanced PIP
[] Reset Audio/Video
Use these buttons on the remote:
[_--]AOJUST_ ENTERr_ ME.Uto
to select to enter go back
]
You will see the Advanced
Features screen. Use the
ADJUST buttons to select
"Set the ti:aer." Press ENTER.
[] SET THE TIMER
O Day : Sunday
_ tart time : -
Input : - -
IOI Channel : - _-
The TV will turn on at a day and time
you select. It will then turn off in
five minutes unless a button is pushed.
Use these buttons on the remote:
r_ ADJUST to select the day
[] ENTER to enter [_ MENU to go back
Use the ADJUST buttons and
the ENTER button to set Day,
Start time_ Input, and Channel.
After setting the timer, make sure
that the program timer indicator
is lit. The iindicator will light in
orange when the TV is turned on
and light in red when the 7_ is
turned off. The indicator will not
light when. using the menus, or
when a lock message is displayed.
If you press the CANCEL button
while setting the timer, the arrow
will move to the previous item. To
clear the timer, press CANCEL
with the arrow next to ':'Day."
When the timer turns the Projection TV on, the display will flash.
If you do not press any function buttons for about 5 minutes, the
Projection TV will automatically turn off. l='re,_s a function button
(such as the display button) to keep the Projection TV on and turn
off the flashing display.
Using the Advanced Features 49