Setup guide

Adjusting the sound (cont.)
The "Speaker" function allows you to select how the Projection
TV's speakers will be used.
• Choose "Internal" if you want to play the Projection TV's sound
through its built-in speakers.
• Choose "Internal Center Channel" if you connected your TV
to a surround sound processor and you want _o use the TV's
built-in speakers as center channel speakers.
• Choose "External" if you connected speakers to the speaker
terminals on the rear of the TV, or if you wa_t to play tlhe sound
of your TV through an audio system.
The "Monitor out" function determines how thc_ TV will send an
audio signal to an audio system or home theal_er receiver. Your
choices are "Variable" or "Fixed."
• If you choose "Fixed," the 2_ will send out al_ audio signal at a
fixed volume level. The level will not change when you .'adjust
the TV's volume. Use the controls on your audio system to
adjust the volume. The "Fixed" setting is most useful wlhen you
can control the audio system's volume with a remote control.
• If you choose '_V'ariable," the TV's audio output will change
when you change the TV_s volume. If you use this setting with
an audio system, turn the TV_s volume all the way down, set the
audio system's volume to an average setting, then turn the TV_s
volume up until you can hear the signal.
42 Chapter 2: Operating Your Projection TV