Setup guide

adjusting the alignment
0
If the test screen shows a single, solid white cross, the ]Projec-
tion TV's tubes are aligned correctly. Skip to step O. If' you see
three crosses, or if the sing]e cross has discoloration at its
edges, go to step O.
O When you first display the "test" screen, the word "Red" ap-
pears at the top of the screen. This indicat;es that you will be
adjusting the red cross on the screen.
Adjust the position of the red cross until it is perfectly aligned
with the green cross at the center of the screen. To adjust the
red cross, use the ADJUST buttons on the remote, or the
ADJUST, VIDEO, and AUDIO buttons on the control panel.
When you've finished adjusting the red cross, press ENTER.
The word "Blue" will appear at the top of the screen.
O Adjust the position of the blue cross until it is perfectly aligned
with the green and red crosses at the center 9f the screen. You
can use the ADJUST buttoas on the remote, or the ADJUST,
VIDEO, and AUDIO buttons on the control panel.
O When all three crosses are perfectly aligned, they should
appear as a single, solid white cross.
O To remove the "test" screen from the Projection TV, press the
ENTER button on the remote, or the ENTER and ADJUST-
down buttons on the control panel.
• Warning: The "test" screen should not be left on the screer for a long periodof time. It could cause damage to the picture tubes.
_>Important: The alignment of the colors can change over time. If you notice a
change in the color quality of the Projection TV's picture, check the
color alignment. You may need to adjust the colors periodically.
Getting Started 35