Setup guide

Using the remote" control to operate VCRs, (;able
boxes, and other equipment
about your remote control
This Projection TV's remote control has four "layers": the _i_ layer,
the VCR-A layer, the VCR-B layer, and the ALVXlayer. Each layer
can be used to operate a different component iin your A/V system.
You select the layer you want to use by pressing one of the "select"
buttons across the top of the remote control.
When you first receive your remote control, the _.W layer is set up
to operate your Mitsubishi Projection TV, the VCR-A and VCR-B
layers are programmed to operate Mitsubishi VCRs, and the AUX
layer is set to operate Mitsubishi audio components.
You can use the following buttons to operate your Projection TV.
power button
pause button
mute control
super quick view button
quick view button
volume control
input button
channel control
enter button
audio and video controls
StarSight function buttons
menu button
cancel button
display button
home button
off-timer button
number buttons
PIP controls
PLAY button
If you have a cable box, a non-Mitsubishi VCR, a Mitsubishi
laserdisc player, or a Mitsubishi A/V receiver, you can "set up" the
layers in the remote control to operate these components.
The VCR-A layer can be set to operate a non-Mitsubishi VCR; the
VCR-B layer can be set to operate any VCR, any cable box,. or a
Mitsubishi laserdisc player; the AUK layer can be set up to operate
a cable box, laserdisc player, or A/V receiver; and the TV layer can
be set to operate an A/V receiver.
setting up the remote control to operate your VCR
1111Turn off your VCR.
Press one of the select buttons across the top of the remote to
choose the layer you want to set. up: VCR-A or VCR-B.
O While holding in the POWER button on the :remote control,
enter the code number listed in the chart on the following page
for your brand of VCR. Be sure to enter both digits of the ('.ode
number. If more than one number is listed, try the first one.
Getting Started 15