Operation Manual

Selecting a preferred bearer

When defining mixed (Circuit+Packets) based profiles, you have to select the first

bearer to use when starting a connection.

To select a preferred bearer,

Validate the Secure port and press OK .

Enter the Home page address and press OK .

Select the security setting (On or Off) and press Select .

To activate the required profile, use or to select it from

the displayed list. Press to validate.

Press Exit or to return to the standby display.

1. You can also access the Internet menu directly by pressing the Internet softkey from the standby

display (provided you haven't personalised the left softkey).

2. If the PPP access phone number, login names and password, Home page http address and IP

address are not predefined, these are obtainable from your network operator and/or internet

provider.

3. Selecting PPP Access or Proxy again will allow you to change and/or modify any of your set-

tings.

Press . Select Internet.

Select Preferred bearer.

Select Circuit or Packets.

Packets selected or Circuit selected will be displayed.

Press Exit or to return to the standby display.

This setting applies to all mixed profiles.