Specifications

ManualsBrandsMitsubishi ManualsDomestic AppliancesSRC50CA

(4) Removal and installation of the front panel

1 Removal

¡ Remove fixing screws (2 places).

¡ Lift the lower part of panel toward you, then remove the

panel by pushing up its upper portion.

2 Installation

¡ Remove the air filter without fall.

¡ Put the front panel on the main unit.

¡ Push the portion shown by

in the below illustration

rearward.

¡ Tighten fixing screws (2 places).

¡ Set the air filter.

(5) Open/close and detachment/attachment of suction grille

1 To open, pull the grille at both ends of lower part and release

latches, then pull up the grille until you feel resistance. (The

suction grille stops at approx. 60˚ open position.)

2 To close, hold the grille at both ends of lower part to lower

downward and push it slightly until the latch works, then

push the center portion slightly.

3 To remove, pull up the grille to the position shown in below

illustration and pull it toward you.

4 To install, insert the suction grille arm into the slot on the

front panel from the position shown in below illustration,

hold the panel at both ends of lower part, lower it downward

slowly, then push it slightly until the latch works and further

push the center portion slightly.

For power supply, indoor outdoor

1 Brown

2 Blue

5.3 Installation of outdoor unit

1 Make sure that the unit is stable in installation. Fix the unit to

stable base.

2 Perfrom wiring, making wire terminal numbers conform to

terminal numbers of indoor unit terminal block.

Claw (3 places)

Attaching arm

Push these portions

Fixing screw

¡ 06, 07, 09 type

Wiring clamp

Terminal block

Interconnecting wire