Specifications

-
52
-
Pipe
Drain hose
(3) Preparation of indoor unit
1 Mounting of connecting wires
a Remove lid.
b Connect the connection wire securely to the terminal block.
¡ Affix the connection wire securely to the terminal block.
If the wire is not affixed completely, contact will be poor,
and it is dangerous as the terminal block may heat up and
catch fire.
¡ Take care not to confuse the terminal numbers for indoor
and outdoor connections.
¡ Affix the connection wire using the wiring clamp.
c Attach the lid.
Terminal Block
Wiring Clamp
Connecting Wiring
Cover
Lid
Pull the part marked
while pushing
its part in the direction of allow so as
to dismount it. (Dismount or detach it
for each side).
2 Shaping the pipe 3 Taping of the exterior
¡ Hold the bottom of the pipe and change its direc-
tion before stretching it and shaping it.
¡ Tape only the portion that runs through the wall.
Always tape the crossover wires with the pipe.
4 Cautions when piping from the left and the rear center of the unit
[ Top View ]
¡ Loosen and remove the
spring-type clamp.
¡ Remove with your hand
or a pair of pliers.
¡ Use a hexagonal wrench to
correctly insert the drain
cap which was removed in
2.
Caution: Be careful be-
cause if the cap is not in-
serted property, water leak
may occur.
¡ Loosen the spring-type clamp
and securely insert the drain
hose.
Caution: Be careful because if
the cap is not inserted properly,
water leak may occur.
Right
Rear
Under
Left rear
Left
Right rear pipingLeft rear piping
Left side piping Right side piping
For power supply, indoor outdoor
For power supply, indoor outdoor
1 Brown
2 Blue