Specifications

-
51
-
1 Fixing of installation board
5.2 Installation of indoor unit
(1) Installation if installation board
(Inserting sleeve)
Indoor side Outdoor side
Turn to
tighten
Paste
View of sleeve when installed
Inclined
flange
Sealing
plate
Sleeve
Indoor side Outdoor side
(*Sleeve + *Inclined + *Sealing plate)
3 Install the sleeve
Lock for the inside wall structures (Intermediate support
or pillar) and fairly install the unit after level surface has
been checked.
Tapping Screws
Mating make for level surface
(Horizontallty)
50
75 615
450
60
100
40
Gas pipe 370
Liquid pipe 420
92
Ø65
Ø65
9
65
236.54.5
36
36
15
19
15
46
Service space
Position for the
hole in the wall
Position for the
hole in the wall
Service space
Service space
Service
space
Indoor unit
Installation
board
150
150
Relation between setting plate and indoor unit
¡ 06, 07, 09 type
Relation between setting plate and indoor unit
50
760
450
15
100
51
Gas pipe 390
Liquid pipe 440
67
ø65
ø65
9
40
2606
36
36
15
15
46
Service space
Position for the
hole in the wall
Position for the
hole in the wall
Service space
Service space
Service
space
Indoor unit
Installation
board
170
170
15
¡ Adjustment of the installation board in the
horizontal direction is to be conducted with
four screws in a temporary tightened state.
¡ Adjust so that board will be level by turning
the board with the standard hole as the
center.
Standard hole
¡ 12 type
Note (1) Drill a hall with incline of 5 degree from
indoor side to outdoor side.
Indoor side Outdoor side
Cut off the sleeve
collar in case of
drawing piping
out to rear.
Cut off the sleeve
collar that can be
seen from beneath
the unit.
Wall thickness
+ 1.5 cm
1 Drill a hole with ø65 whole core drill 2 Adjusting sleeve length
(2) Drilling of holes and fixture sleeve (Option parts)