Specifications

CHAPTER 4 SYSTEM CONNECTION
4.2 Connection of Control Unit
23
4.2.3 Connection of Floppy Disk Drive
(1) Connection of F130 cable
Connect the floppy disk drive to CFD on the control unit. Refer to Appendix 2 (F130 cable) for the
floppy disk drive cable.
Control unit
CF11
F130 cable
CFD
Floppy disk drive
Signal
Power supply
Connect the F130 cable and floppy disk drive as shown below. Place the PCB side downward and
face the connector incorrect insertion prevention key upward when inserting.
F130 cable
Incorrect insertion prevention key
Rear side of floppy disk drive
PCB side
Power
supply
Signal
(2) FDD installation conditions
The FDD body must be installed so that it is within ±25° of the vertical or horizontal directions.
The FDD cannot be used if the disk insertion port is inclined (other than vertical/horizontal).
Within 25°
Within 25°
FDD
disk
Front face
Do not apply voltages other than those indicated in this manual on the connector. Doing
so may lead to destruction or damage.
Incorrect connections may damage the devices, so connect the cables to the specified
connectors.
CAUTION