Installation manual

–5–
Startup Screen
[Startup Screen] [Information Screen]
This screen is displayed at startup. Note
After a brief time, the following screen is displayed. It is not possible to do any setting when information
screen is displayed.
• ALL GROUPS Display
This display appears the first time the unit starts up or when block have not been registered. Make the initial
settings in the following order.
Time & Date Setting page 11
Group Definition page 11
Block Definition page 13
* Once blocks are registered, it is very convenient because the status of all groups can be viewed on a single
screen.
• ALL BLOCKS Display
When blocks have been registered, this display appears.
Note
It may take time for the settings to be read into the unit. Do not perform any operations until all the groups
that have been set are displayed. (This should take only a few minutes.)