Installation manual

–29–

4. Press the OK button.

A confirmation screen (Calculating data file export confirmation screen / Definition file backup confirmation

screen) is displayed. Press the “OK” button on either of the screens.

Note

• If the CANCEL button is pressed, it returns to the previous screen.

• The “Import a configuration file from USB” button is not needed.

• See the bundled CD-ROM for calculating on a PC.

Important!!

Calculating Data

(1) Follow the above procedure to transfer the calculating data to USB memory.

(2) Remove the USB memory from the central control and connect it to a PC.

(3) Insert the CD-ROM that was bundled with this unit into the PC and start the software.

(4) Operate the software according to the CD-ROM menu.

* There is no need to have the USB memory connected to this unit at all times.

* After installing the calculating data software, steps (3) and (4) are unnecessary. Operate

the software with reference to the manual on the CD-ROM.

1. Press IMPORT EXPORT button on the MAIN MENU.

Page 7

2. Press the “Export a configuration file to USB” button.

Select the folder on the Folder Selection screen.

Page 28

Note

• If the BACK button is pressed, it returns to the previous screen.

• The “Import a configuration file from USB button” is not needed.

By backing up the Definition data, the following data can be easily backed up;

· Block and group definitions

· Schedule settings

[Import/Export screen]