User`s manual

– 8 –

1. Press the MENU button and select .

Each time you press this button, the display moves to the next step in the sequence in the diagram below.

The ﬂashes.

2. Press the SET button.

The

lights up and “01-00” ﬂashes.

3. Press the GROUP No. button for the group to be set.

The selected group number ﬂashes.

Example: 02-00

4. Press the SELECT (

or ) button to set the indoor unit number.

The selected unit number ﬂashes.

Example: 02-05

Steps

3 and 4 can be in either order.

5. Press the SET button.

The group number and unit number light up and after 2 seconds, ﬂash.

With this, the display unit number is registered as the display group number.

If you register a unit number that had not been registered before this, the number of managed units increases.

To change an indoor unit number within the same group, repeat Steps

4 and 5.

To change the group number and to make group settings, repeat Steps

3 to 5.

Note

To end the setting or to cancel settings being made, press the MENU button.

It is possible to set units with consecutive addresses all at once.

Page 11

•

Off