Hardware manual

Chapter2 Connection to a PLC
2-206
Extended counter
contact
WEC EC 0 - 7F R (*1)
Extended present
value register
EN EN 0 - 7FF R
Extended data
register
U U 0 - 7FFF R/W
Extended special
register
ES ES 0 - 7FF R/W
Extended setup value
register
H H 0 - 7FF R/W
Extended input WGX GX 0 - FFF R/W (*4)
Extended output WGY GY 0 - FFF R/W (*4)
Extended internal
relay
WGM GM 0 - FFF R/W (*4)
Extended Buffer
register 0
EB0 EB 0 - 7FFF R/W (*4)
Extended Buffer
register 1
EB1 EB 8000 - FFFF R/W (*4)
Extended Buffer
register 2
EB2 EB 10000 - 17FFF R/W (*4)
Extended Buffer
register 3
EB3 EB 18000 - 1FFFF R/W (*4)
- (*1) Parameter-set program No. in “Link parameter” is an objective of command processing.
When the built-in standard link parameters are not set, Probram1 is an objective of
command processing.
- (*2) When CPU operation mode is division mode, File register is not available.
- (*3) R/W
：
Read and Wirte device R
：
Read only device
- (*4)These devices are available in the case of a PC3JG mode.
- Depending on the type of CPU operation mode of PC3J that you will be using, the there are
limits to the areas that can be used within the device ranges given above. Refer to the PLC
manual for details.