Hardware manual

6 Keyence
2-173
Chap.2
・ Word Device
Device Symbol
Device Name
HG PLC
Address Range
Read
/Write
Address
Gradual
Timer (Preset) TS T 0 - 39991 R (*1)
Timer (Current) TC T 0 - 39991 R (*1)
Counter (Preset) CS C 0 - 39991 R (*1)
Counter (Current) CC C 0 - 39991 R (*1)
High-speed counter
(Current)
CTH TCH 00 - 11 R (*1)
High-speed counter
comparator (Preset)
CTCS CTC 00 - 31 R (*1)
Data Memory DM DM 0 - 65534 R/W
Exp Data Memory E EM EM 0 - 65534 R/W
Exp Data Memory F FM FM 0 - 32766 R/W
Temporary Memory TM TM 0 - 511 R/W
Control Memory CM CM 0 - 11998 R/W (*2)
Index Resistor Z Z 1 - 12 R/W
(*1) These devices are 32-bit devices.
When using these devices, please add an extra Zero to the PLC address as shown below.
Ex: In case of setting Timer (Preset)
PLC: T511, WindO/I-NV2: T5110
(*2) Some addresses are read only devices. Refer to the PLC manual for details.
(*3)R/W: Read and Write device, R: Read only device
- Only a reset action is possible for a High-speed counter comparator (Relay).
- If set operation is performed, since a communication error will occur, please do not use it.
- The address range is dependant on the PLC model. Refer to the PLC manual for details.