Hardware manual

Chapter2 Connection to a PLC
2-140
4.5.4 Ethernet/IP
If you select Ethernet/IP as Host I/F driver, the driver contains some PLCs devices.
Therefore, the following devices name may be not same as devices name for each PLC.
Refer to the following cross reference table about detail.
・ Bit Device
Device Symbol
Device Name
HG PLC
Address Range
Read
/Write
Address
Gradual
SLC/MicroLogix Input SI I 0 - 1625515 R 10 (*1)
SLC/MicroLogix Output SO O 0 - 1625515 R 10 (*1)
PLC-5 Input PI I 0 - 27717 R 10 (*2)
PLC-5 Output PO O 0 - 27717 R/W 10 (*2)
Binary B B 0 - 99999915 R/W 10 (*3)
Timer Enable bit TEN TEN 0 - 999999 R 10 (*4)
Timer Timing Bit TTT TTT 0 - 999999 R 10 (*4)
Timer Done Bit TDN TDN 0 - 999999 R 10 (*4)
Counter Up Enable Bit CCU CCU 0 - 999999 R 10 (*4)
Counter Down Enable Bit CCD CCD 0 - 999999 R 10 (*4)
Counter Done Bit CDN CDN 0 - 999999 R 10 (*4)
Counter Overflow Bit COV COV 0 - 999999 R 10 (*4)
Counter Underflow Bit CUN CUN 0 - 999999 R 10 (*4)
Counter Update Accumulator CUA CUA 0 - 999999 R 10 (*4)
Control Enable Bit REN REN 0 - 999999 R 10 (*4)
Control Queue Bit REU REU 0 - 999999 R 10 (*4)
Control Aynchronous Done Bit RDN RDN 0 - 999999 R 10 (*4)
Control Synchronous Done BIt REM REM 0 - 999999 R 10 (*4)
Control Error Bit RER RER 0 - 999999 R 10 (*4)
Control Unload Bit RUL RUL 0 - 999999 R 10 (*4)
Control Running Bit RIN RIN 0 - 999999 R 10 (*4)
Control Found Bit RFD RFD 0 - 999999 R 10 (*4)