Hardware manual

Chapter2 Connection to a PLC
2-126
4.5 Compatible Devices
The types of compatible devices and their ranges are shown below. Device address selection for
the MicroLogix1200, SLC 500 and PLC-5 CPUs are is done using File No., Element No., Bit No.
etc., with an appropriate delimiter. But the WindO/I-NV2 address selection is done without the
delimiter. The MICRO/I address specification syntax (address specification rules) is explained
below. Follow the syntax below when performing address selections using WindO/I-NV2
software.
MICRO/I support the following device types and range.
WindO/I-NV2 supports the device address format as same as MicroLogix, SLC 500, PLC-5
programming software along with the standard device address format of WindO/I-NV2.
Standard device address format of WindO/I-NV2
File Number, Element and Bit Number are separated by some delimiters in device address
format of Allen-Bradley’s software.
However, standard device address format of WindO/I-NV2 does not contain delimiters.
It is remove some delimiters from Allen-Bradley’s device address format.
Allen-Bradley device address format
This device address format is same as the device address format of Allen-Bradley’s software.
(Some part of the format is deferent. Refer to the following.)