Hardware manual
3 Omron
2-105
Chap.2
3.4.5 CS1 Series (Communication Board) Settings
Write the Communication Board setting items for the System Settings Area using a peripheral
tool (such as Procon).
System Settings
Area
Port 1 Port 2
Item Setting
Optional/Initial Setting (*1) Set to 1 for Optional Setting
Serial Communication
mode
Set to PLC Link
Data Bits
Stop Bits
DM32000 DM32010
Parity
Use the same settings as for the
MICRO/I.
DM32001 DM32011 Port Communication Speed Use the same settings as for the
MICRO/I.
Transmission Delay setting 0 for default (0mses) DM32002 DM32012
Delay time setting
CTS control Set to 0 for no DM32003 DM32013
Unit No. Use the same settings as for the
MICRO/I.
(*1) Initial settings
Baud rate: 9600bps
Data Bits: 7 bits
Stop Bits: 2 bits
Parity: Even
Set the DIP switch 4 line.
Set the DIP switch to ON to turn the termination resistor setting ON.