User`s manual
A - 5 A - 5
9.10 Integration (S.I)..................................................................................................................................... 9 - 61
9.11 Differentiation (S.D)..............................................................................................................................9 - 63
9.12 Dead Time (S.DED) ............................................................................................................................. 9 - 65
9.13 High Selector (S.HS)............................................................................................................................9 - 68
9.14 Low Selector (S.LS) .............................................................................................................................9 - 70
9.15 Intermediate Value Selection (S.MID)..................................................................................................9 - 72
9.16 Average Value (S.AVE)........................................................................................................................9 - 75
9.17 Upper /lower Limiter (S.LIMT).............................................................................................................. 9 - 77
9.18 Change Rate Limiter 1 (S.VLMT1) ...................................................................................................... 9 - 79
9.19 Change Rate Limiter 2 (S.VLMT2) ...................................................................................................... 9 - 81
9.20 2-position ON/OFF (S.ONF2) ..............................................................................................................9 - 83
9.21 3-position ON/OFF (S.ONF3) ..............................................................................................................9 - 89
9.22 Dead Zone (S.DBND) .......................................................................................................................... 9 - 95
9.23 Program Setting Device (S.PGS).........................................................................................................9 - 97
9.24 Loop Selector (S. SEL)........................................................................................................................ 9 -102
9.25 Bump-less Transfer (S.BUMP) ...........................................................................................................9 -108
9.26 Analog Memory (S.AMR) ....................................................................................................................9 -110
10. COMPENSATION OPERATION INSTRUCTIONS 10 - 1 to 10 - 15
10.1 Polygon (S.FG)...................................................................................................................................10 - 1
10.2 Inverted Polygon (S.IFG).................................................................................................................... 10 - 3
10.3 Standard Filter (S.FLT).......................................................................................................................10 - 5
10.4 Retentive (S.SUM) .............................................................................................................................10 - 8
10.5 Temperature/Pressure Compensation (S.TPC)................................................................................10 - 10
10.6 Engineering Value Conversion (S.ENG)............................................................................................10 - 12
10.7 Engineering Value Reverse Conversion (S.IENG)............................................................................10 - 14
11. ARITHMETIC OPERATION INSTRUCTIONS 11- 1 to 11 - 12
11.1 Addition (S.ADD) ................................................................................................................................ 11 - 1
11.2 Subtraction (S.SUB)...........................................................................................................................11 - 3
11.3 Multiplication (S.MUL) ........................................................................................................................11 - 5
11.4 Division (S.DIV) .................................................................................................................................. 11 - 7
11.5 Extraction (S.SQR)............................................................................................................................. 11 - 9
11.6 Absolute Value (S.ABS) ..................................................................................................................... 11 - 11
12. COMPARISON OPERATION INSTRUCTIONS 12- 1 to 12 - 10
12.1 Comparison (S. ) ............................................................................................................................12 - 1
12.2 Comparison (S.
) ............................................................................................................................ 12 - 3
12.3 Comparison (S.
)............................................................................................................................ 12 - 5
12.4 Comparison (S.
)........................................................................................................................12 - 7
12.5 Comparison (S.
)........................................................................................................................12 - 9
13. AUTO TUNING 13- 1 to 13 - 12
13.1 Auto Tuning Instruction (S.AT1)......................................................................................................... 13 - 4