User`s manual

58
2.3 Settings for Using the Programmable Controller CPU
Monitoring Function
This section describes system settings required for constant cycle transmission and condition agreement transmission.
2.3.1 System setting items for the programmable controller CPU
monitoring function
The following explains system setting items for the programmable controller CPU monitoring function.
● Register transmission user frames by GX Configurator-SC, after checking the specifications and setting methods
explained in Page 220, CHAPTER 9 and Page 252, CHAPTER 11 of this manual.
● Register connection data for the modem function by GX Configurator-SC, after checking the specifications described in
Page 139, Section 3.4.4 of this manual.
(1) Setting items and requirement when performing communication using the MC
protocol
Setting item
Constant cycle transmission
Condition agreement
transmission
Reference section
Data
transmission
Notification
*1
Data
transmission
Notification
*1
Cycle time units Page 61, Section 2.3.1 (3) (a)
Cycle time Page 61, Section 2.3.1 (3) (b)
PLC CPU monitoring function  (1H: Constant cycle)  (2H: Condition agreement) Page 61, Section 2.3.1 (3) (c)
PLC CPU monitoring transmission measure  (Data)

(Notification)
 (Data)

(Notification)
Page 61, Section 2.3.1 (3) (b)
Constant cycle
transmission
Transmission pointer


Page 38, Section 2.2.2 (4)
Page 288, Section 11.4.2
Output count
Data No. for connection 
Page 56, Section 2.2.5 (3)
Page 139, Section 3.4.4