User`s manual

57
CHAPTER 2 USING THE PROGRAMMABLE CONTROLLER CPU MONITORING FUNCTION
2
2.2 About the Programmable Controller CPU Monitoring Function
2.2.6 Execution sequence for using the programmable controller
CPU monitoring function
The following explains the execution sequence for using the programmable controller CPU monitoring function.
(1) When transmitting the monitoring results through data
transmission/notification messages using the modem function, perform the
following settings in order to use the modem function.
(2) Register programmable controller CPU monitoring for the Q series C24 using
one of the methods described in Page 36, Section 2.2.1.
(3) By registering programmable controller CPU monitoring, the Q series C24
monitors the local station's programmable controller CPU regardless of the
RUN/STOP status and sends the monitoring information to the external device.
(4) When reregistering programmable controller CPU monitoring in order to
change the registration data for the programmable controller CPU monitoring,
reregister after canceling the programmable controller CPU monitoring.
(a) When registering with communication using the MC protocol
( MELSEC Communication Protocol Reference Manual)
(b) When registering with the programmable controller CPU's "CSET" instruction (
Page 203, CHAPTER 7)
To cancel when using GX Configurator-SC, change the programmable controller CPU to the STOP status, redo
the settings, and then restart the QCPU.
Setting item Reference section
Initial setting by GX Configurator-SC Page 131, Section 3.4.2
Registration of data No. for initialization and data No. for connection Page 134, Section 3.4.3, Page 139, Section 3.4.4
Initialization of the Q series C24 modem/TA Page 144, Section 3.4.5