User`s manual

408
*1 Perform programming so that data communication processing is not executed while the interlock signal for
communication stop (M100) is ON.
Clears the control data
Always sets 0
Sets the execution type to 0
Clears the execution result to 0
Sets the CH1 communication protocol
Sets the CH2 communication protocol
Sets the host station No.
Executes the UINI instruction
Processing for normal completion
Processing for error completion
Data communication processing
UINI
instruction
command
CH1 mode
switching
request
CH2 mode
switching
request
CH1 mode
switching
CH2 mode
switching
Interlock signal for
communication stop
(
*1
)
Sets the CH1 transmission specifications
Sets the CH2 transmission specifications
Turns ON the interlock signal for
communication stop
*1
Turns OFF the interlock signal for
communication stop
*1