User`s manual

406
[Operation when the UINI instruction is executed]
17.8.4 Errors
When the dedicated instruction is completed with an error, the status display device at completion ((D)+1), turns on
and the error code is stored in the control data transmission result ((S1)+1).
See the following manuals regarding the error code, and check the errors and take corrective actions.
<Error codes>
4FFFH or less: User's manual (hardware design, maintenance and inspection) for the CPU module used
7000H or higher: User's Manual (Basic)
ON
OFF
ON
ON
OFF
OFF
UINI instruction
One scan
UINI instruction execution
END
processing
END
processing
END
processing
END
processing
Setting processing
Communication disabled
Q series C24
Sequence
program
Completion
device
Status indication
device at completion
Mode switching
signal (X6/XD)
Normal completion
Error
completion