User`s manual

401
CHAPTER 17 DEDICATED INSTRUCTIONS
17
17.7 G(P).PUTE
17.7.4 Errors
When the dedicated instruction is completed with an error, the status display device at completion ((D)+1), turns on
and the error code is stored in the control data registration/deletion result ((S1)+1).
See the following manuals regarding the error code, and check the errors and take corrective actions.
<Error codes>
4FFFH or less: User's manual (hardware design, maintenance and inspection) for the CPU module used
7000H or higher: User's Manual (Basic)
17.7.5 Program example
The following shows an example of a sequence program when registering user frames.
Data set for the program example are as follows:
When the input/output signals of the Q series C24 are X/Y80 to X/Y9F
Setting item Setting data
User frame No. 3E8H
Registration data (10 bytes)
Binary 46H,39H,30H,30H,30H,30H,46H,46H,30H,30H
ASCII F90000FF00
Registration request
Sets the registration request
Sets the frame number to be registered
Sets the number of registration data
bytes
Sets the flash ROM write allow
Executes user frame registration
Normal completion
Abnormal completion
Sets the registration data for the frame
to be registered in D4 to D8