User`s manual

399
CHAPTER 17 DEDICATED INSTRUCTIONS
17
17.7 G(P).PUTE
Remark
● For information about errors caused by incorrect data designated by the user, see the description in "Errors".
● The "Set by" column indicates the following:
• User: Data set by the user before executing the dedicated instruction.
• System: The programmable controller CPU stores execution results of the dedicated instruction.
17.7.3 Functions
(1) This instruction registers or deletes the user frame for the Q series C24 as
designated by Un.
(2) When registering a user frame
(a) When registering a user frame, set 1 to the device for (S1)+0.
Data in the device designated by (S2) and after will be registered according to the control data.
(b) The registered data should be stored in the device designated by (S2) and after as
described below.
Thus, at least (registered data number)/2 devices will be necessary to store the registered data and they
should be assigned beginning with the device designated by (S2).
For example, when registering 6 bytes of data, 3 devices beginning with the device designated by (S2) will be
used.
(3) When deleting a user frame
(a) When deleting a user frame, set 3 to the device for (S1)+0.
The user frames of the frame numbers designated by (S1)+2 will be deleted.
(b) The registered byte number designated by (S1)+3 and registered data storage
device designated by (S2) are not used by the PUTE instruction, but they are
necessary for formatting it.
Designate 1 to 80 for (S1)+3 and a dummy device for (S2).
(S2)+0
+2 EF
AB
QCPU
+1
b0b7b8b15
C
D
F
E
C
D
B
A
User frame
Register
to to
Q series C24
Registered byte length