User`s manual

376
17.3.2 Control data
(1) Registering the programmable controller CPU monitoring
Device Item Setting data Setting range Set by
(S2)+0 Execution type Designate 0. 0 User
(S2)+1 Completion status
Stores the result of execution upon completion of an instruction.
0: Normal
Other than 0: Error code
 System
(S2)+2 Request type
Designate the request content.
2: Registers programmable controller CPU monitoring.
2
User
(S2)+3 Cycle time units
Designate the unit of cycle time.
0: 100ms
1: s
2: min
0 to 2
(S2)+4 Cycle time
Designate the cycle time.
1H to FFFFH: Cycle time
1H to FFFFH
(S2)+5
Programmable controller CPU monitoring
function
Designate the monitoring function.
1: Constant cycle transmission
2: Condition agreement transmission
1, 2
(S2)+6
Programmable controller CPU monitoring
transmission measure
Designate the transmission measure.
0: Data transmission (device data, CPU abnormal information)
1: Notification
*1
0, 1
(S2)+7
Constant
cycle
transmission
User frame output head pointer
Designate the head pointer of the table setting the user frame
numbers for constant cycle transmission.
0: No designation (at condition agreement transmission and
notification
*1
)
1 to 100: Head pointer
0, 1 to 100
(S2)+8 User frame transmission count
Designate the user frame transmission (output) counts for
constant cycle transmission.
0: No designation (at condition agreement transmission and
notification
*1
)
1 to 100: Transmission count
0, 1 to 100
(S2)+9 Modem connection data No.
Designate the data No. for connecting the modem function when
sending notifications in constant cycle transmission.
*2
0: No designation (at data transmission and condition agreement
transmission)
BB8H to BD5H: Data No. for connection (flash ROM)
8001H to 801FH: Data No. for connection (buffer memory)
0,
BB8H to
BD5H,
8001H to
801FH
(S2)+10 Registered word blocks count Designate the number of blocks of a word device to be monitored. 0 to 10
(S2)+11 Registered bit blocks count Designate the number of blocks of a bit device to be monitored. 0 to 10
(S2)+12
Programmable controller CPU abnormal
monitoring
(Programmable controller CPU status
monitoring)
Designate whether or not to execute abnormal monitoring for the
programmable controller CPU.
0: Do not monitor.
1: Monitor.
0, 1
(S2)+13
Programmable
controller CPU
monitoring setting
Device code
Designate the code of a device to be monitored.
0: Do not monitor device.
Other than 0: Device code.
Page 38,
Section 2.2.2
(4)