User`s manual

300
(b) When transparent code/additional code data set for transmission is detected during
data transmission, the additional code designation data is added immediately
before, and is then transmitted.
During data transmission using user frames, even if a transparent code or additional code has been specified
in the send transparent code designation area, it is possible to transmit data without adding the additional code
data to the user frame portion or arbitrary data.
When sending data without adding the additional code data specified by the send transparent code
designation, specify the user frame No. using the following method.
• Specify the number obtained by adding 4000H to the registered user frame No.
When sending the data for the section designated by 4001H to 44AFH and C000H to C01FH, data will be sent
without conversion even if "Enable" has been specified in the ASCII-BIN conversion designation area. (
Page 321, Section 13.3)
No. of the use frame to be sent
Designation No. when sending data without adding the
additional code specified by the send transparent code
designation.
1H to 3E7H (1 to 999) 4001H to 43E7H (16385 to 17383)
3E8H to 4AFH (1000 to 1199) 43E8H to 44AFH (17384 to 17583)
8000H to 801FH (-32768 to -32737) C000H to C01FH (-16384 to -16353)
b15 b14 b0b13 to
Frame No.
0: Conversion enable 1: Conversion disable
0: Frame registered in flash ROM 1: Frame registered in the buffer memory