User`s manual

292
• Output count designation area (addresses: B9H/159H)
Write the output count of the user frames to be sent from the position designate in the output head pointer
designation area.
Remark
The operation is completed normally without data transmission if the value for the output count designation area is "0."
• Transmission frame No. designation area (addresses: BAH to 11DH/15AH to 1BDH)
• Write the user frame No. to be sent in the order in which they are output from the position designated in
the output head pointer designation area.
• When sending data that is written in the transmission area, use 8000H as a temporary user frame number.
• By designating user frame number 8000H, the Q series C24 transmits the data of the transmission data
designation area for the data count designated in the transmission data count designation area.
The following transmission can be performed by adding 4000H to the registered user frame No. and specifying this number.
• When ASCII-BIN conversion is designated, a specified frame can be sent without the conversion. ( Page 321,
Section 13.3)
• A specified frame can be transmitted without adding the additional code for the send transparent code
designation. ( Page 299, Section 12.3)
B9H
159H
b15 b0
0
1
100
0 to 100
to
0 to 100
(CH1 side)Buffer memory address
(CH2 side)
: No designation
: Transmit 1 frame
: Transmit 100 frames
to to
BAH
11DH
15AH
1BDH
toto
0H to 801FH(1st)
0H to 801FH(100th)
0H to 801FH(1st)
0H to 801FH(100th)
(CH1 side)
Buffer memory address
(CH2 side)
to to
0H
1H to 3E7H/4001H to 43E7H
3E8H to 4AFH/43E8H to 44AFH
8000H/C000H
8001H to 801FH/C001H to C01FH
: No transmission designation. (No additional transmission is allowed.)
: Transmits the default frame having the designated number.
: Transmits the user frame having the designated number. (For flash ROM registration)
: Transmits data in the transmission area of the buffer memory.
: Transmits the user frame having the designated number. (For buffer memory registration)
Specifies the following user frame No. for the data to be sent.
Note that the No. on the right side of the user frame No. below is the No. used for transmission without ASCII-BIN conversion for
only the data of any frame section when transmission data is converted into ASCII-binary data
and transmitted. See Chapters 12 and 13 for details.