User`s manual

277
CHAPTER 11 DATA COMMUNICATIONS USING USER FRAMES
11
11.3 Receive Program
*2 Page 267, Section 11.2.4
Sets to CH1 for reception channel
Sets normal completion flag
Sets abnormal completion flag
Executes reception
<First frame No. (for reception) designation, 1st to 4th>
<Last frame No. (for reception) designation, 1st to 4th>
<Reception format designation 2 to 3, format-1 specified>
<Format-1 received data count designation 2 to 3
>
<Set to enable user frame>
<<Start communications after M2 turns ON>>
<<Wait until data communications are enabled>>
<Reception is ready>
<Reads combination No.>
<Reads reception data>
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
\
User frame setting for reception
*2
Reads combination of received
user frames
Sets to 20 for No. of allowable
reception data