User`s manual

152

(5) Line connection program example

An example of a line connection program is shown below.

(a) Example of initiating line connection from the Q series C24 side following the

initialization completion

When the data for connection has been registered from GX Configurator-SC or from the programmable

controller CPU.

*1 Page 139, Section 3.4.4

*2  Page 134, Section 3.4.3,  Page 139, Section 3.4.4,  Page 144, Section 3.4.5

X1E: Ready signal

M0: Accessible flag

M3: Initialization complete flag

Line connection command

Sets connection request signals

Turns the ready flag ON

M2: Data registration complete flag

for connection

X10: Initialization complete signal

X1F: WDT error signal

M40: Connectable flag

Turns the line connectable

flag ON

When the connection in progress

signal ON (normal completion),

sets the connection complete flag

Reads the error code at connection

abnormal completion

Resets the flag with the clear

command

• Data for initialization registration

• Data for connection registration

• Modem/TA initialization