User`s manual

142
(Data for connection area): 44 bytes
(Notifying message area): 36 bytes (Designated when performing notification)
Data name Designated/stored value and contents
Number of
bytes
Data type
Pager receiver
designation
Whether or not notification is performed, and the notification target module are designated.
0: No notification
3: Notification performed
• In the case of 3 above, the wait time for message transmission in the notification message
must be designated.
2Binary
Telephone number
• The other party's phone number used to establish line connection when communicating
data or performing notification is designated.
• When phone number is less than 18 characters, a space (code: 20H) must be entered for
the remainder.
18 ASCII
External line dialing
number
The external-line access number on Q series C24 side when performing data
communication/notification to the partner device is designated.
0 to 9, 10 (*), 11 (#): External-line access number on the Q series C24 side
255: No external-line access number required on the Q series C24 side
2Binary
Line types
The line type used to perform data communication/notification with the partner device is
designated.
0: Pulse
1: Tone
2: ISDN
2Binary
(Open) Designate "0". 20 Binary
Data name Designated/stored value and contents
Number of
bytes
Data type
Wait time for message
transmission
The wait time after line connection until message transmission is designated.
(Unit: s)
0 to 255: Wait time
• Valid when the pager receiver designation in data connection is "3".
2Binary
Message
Designate the notification message according to the display specification on the other party's
device.
30 Binary
Message length
The number of designated message bytes shown above is designated.
0: No message designation
1 to 30: Number of message bytes
2Binary
(Open) Designate "0". 2Binary