User`s manual

134
3.4.3 Register/read/delete of the initialization data
The section explains the register/read/delete of the data for initialization such as initialization commands for the
modem/TA connected to the Q series C24 side for data communication with the external device, pager receiver
notification and accessing from GX Developer using the modem functions.
(1) Registration destination of the data for initialization
• The data for initialization may be used by registering to the Q series C24 Flash ROM or buffer memory.
• The buffer memory may register the data for connection shown in Page 139, Section 3.4.4 and will register
the data for initialization or data for connection in the designated area.
• It is recommended that the data for initialization during the debug process is stored in the buffer memory.
The registration data in the buffer memory will be erased after starting up the Q series C24 loading station
again. It is necessary to register the data for initialization in the buffer memory after each start-up of the Q
series C24.
• It is recommended to store the data for initialization to the Flash ROM after completing the debug process.
By registering it to the Flash ROM, the registration process of the data for initialization will be unnecessary
thereafter.
(2) Types of data for initialization
• There are data for initialization that are registered in the Flash ROM of the Q series C24 upon shipping and
data for initialization that are set by the user.
• The number of times registered/number of possible registrations are shown in the chart below.
(3) Data for initialization registration number
• The registration numbers shown in the table below are used by the memory of the registration destination.
• The registration number of the data for initialization is determined by the area of registration.
(4) Precautions during the registration of data for initialization
• The maximum size of the initialization commands that may be registered as one data for initialization is 78
bytes.
• Do not include CR/LF (data code: 0DH/0AH) in the data for initialization to be registered to the Q series C24.
The CR/LF is output at the end of the AT command by the Q series C24 when processing initialization
(automatically added).
• The registration status of the data for initialization stored in the Flash ROM may be checked in "data
registration for modem initialization" screen for GX Configurator-SC or the buffer memory (address: 226H to
228H (550 to 552). When newly registering, register by designating an unregistered number. When
designating a registration number that has already been registered, first delete the registration data in the
preoccupied registration number prior to registration.
• When connecting the Q series C24 to an external device using a cellular phone and a modem, set the
transmission rate supported by the cellular communication module on the modem side.
Registration
data
Registration destination Registration number (Decimal (hexadecimal))
Number of
registrations
Data for
initialization
data
Flash ROM
Data registered by the OS 2000 to 2013 (7D0H to 7DDH) 13
Data registered by the user 2500 to 2529 (9C4H to 9E1H) 30
Buffer memory (All are set by the user) -32767 to -32737 (8001H to 801FH) 31