User`s manual

133
CHAPTER 3 COMMUNICATIONS BY THE MODEM FUNCTION
3
3.4 Start-up of the Modem Function
(b) All transmissions using the modem function are transmitted in full-duplex.
Leave the following initial settings for the interface side that uses the modem function as default.
(Default value)
• CD terminal check: Not checked
• Communication method: full-duplex communication
(c) The processes that correspond to the following output signals may not be aborted.
It is recommended to leave the following initial settings for the modem functions as default. (Upon error, it will
end due to time out.)
(Default value)
• Number of connection retries: 3 times
• Connection retry interval: 180s
• Initialization/connection time out: 60s
Also perform the settings for a remote password check described in Page 116, Section 3.3.6 (3) (a) and Page 116, Section
3.3.6 (3) (b) when a remote password check is executed with respect to the remote password set in the QCPU.
Output signal Requesting process name
Y10 Initialization request (standby request)
Y11 Connection request
Y12 Disconnection request
Y14 Notification-issued request