User`s manual

129
CHAPTER 3 COMMUNICATIONS BY THE MODEM FUNCTION
3
3.4 Start-up of the Modem Function
(3) If notification is made
*1 Page 154, Section 3.4.7
0
1
2
3
6
3
Line disconnect
completed.
Pager receiver
Q Series C24 (Line connection side)Modem
Notification-issued request signal (Y14)=OFF.
Line connection
Notification
*1
Line disconnect completed
Notification-issued request (Y14)=ON
Modem initialization completion signal
(X10)=ON
Modem initialization
Modem initialization completed signal
(X10)=ON.
Line connection normally completed
Connection in progress signal (X12)=ON
Line connection
normally completed.
Line disconnect
Notification data
reception.
indicates processing
performed by the user.
(1) Perform the processing up to
the point where the modem/TA is
initialized by the procedure in (1).
Make notification
Shows the value stored for the modem function
sequence status (address 546 (221H))
*