User`s manual

118

• This specifies the connection data registration No. where the callback destination GX Developer side's

telephone No. is registered. Connection data are data that have been registered in the Q Series C24's flash

ROM or buffer memory. See Page 139, Section 3.4.4 for connection data registration.

• In the following case, the connection data telephone No. specified in callback data No. 1 becomes the

callback destination.

• If the callback destination GX Developer is fixed (1 module)

*1 The external line dialing, line types and telephone number in the connection data become valid.

• In the following cases, when the callback destination telephone No. from the GX Developer is specified and

connection made, callback is performed using the external line dialing and line types in the connection data

for the registration No. specified in callback data No. 1.

• If it is being made possible to change callback destination GX Developer

• If the maximum number of callback destination GX Developer is limited to 10 modules

• If the callback destination GX Developer is limited to a maximum of 10 modules, specify the connection data

registration No. that specify the callback destination telephone No. for a maximum of 10 modules.

• The external line dialing, line types and telephone number in callback data No. 1 become valid.

• The telephone No. only becomes valid in callback data No. 2 to 10. The external line dialing and line types

in the connection data for callback data No. 1 are used for these.

• If "0H" is specified in this specification, the callback data No. after that become "unspecified."

If callback data No. 4 is specified as "0H," the callback data No. 4 to 10 registrations become invalid.

(d) Callback permit accumulated count storage area (Address 8944 (22F0H))

The accumulated count value when the Q Series C24 executed callback is stored here.

(e) Callback denial accumulated count storage area (Address 8945 (22F1H))

The accumulated count value for callbacks which the Q Series C24 did not executed due to callback error

detection is stored here.

(f) Auto (callback) connection permit accumulated count storage area (Address 8946

(22F2H))

The accumulated count value for normal line connections from GX Developer by the connection system listed

below is stored here.

• Auto (callback: during fixed)

• Auto (callback: during designated number)

(g) Auto (callback) connection denial accumulated count storage area (Address 8947

(22F3H))

The accumulated count value for line connections from GX Developer by the connection system shown below

that were not connected normally is stored here.

• Auto (callback: during fixed)

• Auto (callback: during designated number)