User`s manual

14
5.2 Connection/Disconnection of Extension Cable
(1) Precautions for handling an extension cable
• Do not step on an extension cable.
• When laying an extension cable, the minimum bend radius of
the cable should be 55 mm (2.17 inch) or more. If it is less than
55 mm (2.17 inch), malfunction may occur due to characteristic
deterioration, wire break etc.
• When connecting or disconnecting an extension cable, do not
hold ferrite cores mounted at both ends of the cable. In case of
connecting/disconnecting a cable, hold the connector part of the
cable.
Holding a ferrite core may cause cable break inside the connector.
Also, if the ferrite core is shifted, the characteristic will change.
When handling the cable, take care not to change position of the
ferrite core.
(2) Connection of extension cable
The following shows extension cables connectable to the QA6ADP.
Model Remarks
QC05B 0.45m cable
QC06B 0.6m cable
QC12B 1.2m cable
QC30B 3m cable
QC50B 5m cable
QC100B 10m cable
Extension
cable
Connector
Ferrite core
Extension
base unit