User`s manual

12
5. MOUNTING AND INSTALLATION
5.1 Mounting/Removal of QA6ADP
(1) Mounting of the QA6ADP
The following shows procedures for mounting the QA6ADP on the
extension base unit.
side connector
Adapter module
mounting screw
Mounting bracket
fixing screw
screw
Adapter module
Connect the Q series extension cable to the
QA6ADP and the upper/lower base unit.
In case of the A5B, connect the
disconnected lead of the FG terminal
(right side).
Tighten the adapter module mounting
screws of the QA6ADP at two parts
(top and bottom), placing a mounting guide.
guide
Mounting
Extension
base unit IN
B)
Connect an extension base unit mounting
connector of the QA6ADP to the IN side of
an extension connector of the extension
base unit.
A)
Mount a board fixing screw of the QA6ADP
to a screw hole (A) at top left of the board.
Utilize a mounting bracket fixing screw to
mount the adapter module mounting
bracket of the QA6ADP into a screw hole
(B) at the bottom left of the board.
Among screws fixing a board of the
extension base unit, remove two at the
left. (Screws A and B shown in the figure.)
In case of the A5B, disconnect a lead of
the FG terminal (right side).
Set the stage number setting connector of
the QA6ADP. (The setting should be same
as that of the stage number setting
connector of the extension base unit.)
Completed
Set the stage number setting connector of
the extension base unit.
Remove a base cover from the extension
base unit.
Disconnect the A series extension cable
from the extension base unit.
Board fixing screw
Adapter module
mounting
bracket
mounting
QA6ADP
Mount an upper mounting screw to a
board fixing screw (at top left) of the
extension base unit.
Mount a lower mounting screw to the
adapter module mounting bracket.