User`s manual

Index - 2 Index - 2
Ind
[O]
OFFGAN......................................................App-5
Offset value ..................................................... 3-3
Offset/gain setting mode flag ........................ 3-16
Offset/gain setting mode ............................... 3-27
Offset/gain settings..................... 4-11, 5-17, 5-19
OGLOAD .....................................................App-7
OGSTOR...................................................App-12
Online module change .................................... 7-1
Open parameter ............................................ 5-11
Operating condition setting completed flag.. 3-15
Operating condition setting request.............. 3-18
Operating environment.................................... 5-4
Output range.................................................. 3-27
Output short circuit protection..................3-1, 3-2
[P]
Part identification nomenclature ..................... 4-3
Pass data..............................................5-24, 5-27
Pass data classification setting..................... 3-28
Programming................................................... 6-1
[Q]
QCPU (Q mode)............................................A-10
[R]
Read from PLC.............................................. 5-11
Resolution mode ........................................... 3-11
RUN LED......................................................... 4-3
[S]
Save parameter............................................. 5-11
Set value change completed flag ................. 3-17
Set value change request ............................. 3-18
Setting range ................................................. 3-27
Setting value specification ............................ 3-27
Setup and procedures before operation......... 4-2
Synchronous output function ........................ 3-11
Synchronous output mode flag..................... 3-17
Synchronous output request......................... 3-18
[T]
Text file ............................................................ 5-7
Transfer setup ............................................... 5-12
Troubleshooting............................................... 8-1
[U]
Uninstalling.......................................................5-2
User range settings offset/gain value............3-28
User range writing request ............................3-18
Utility package..................................................5-1
[V]
Voltage output characteristic ...........................3-4
[W]
Weight ...................................................... 3-1, 3-2
Write to PLC...................................................5-11
[X]
X/Y monitor/test .............................................5-16