User`s manual

6 - 9 6 - 9

MELSEC-Q

6 PROGRAMMING

(2) Operating the utility package

(a) Initial setting (see Section 5.4)

CH1, CH2 D/A conversion enable/disable setting ...."Enable"

CH1 rate control enable/disable setting....................."Enable"

CH1 increase digital limit value.................................."100"

CH1 decrease digital limit value ................................"30"

CH1 disconnection detection setting ........................."Enable"

CH2 warning output setting........................................"Enable"

CH2 warning output upper limit value........................"10000"

CH2 warning output lower limit value ........................"3000"

(b) Auto refresh setting (see Section 5.5)

CH1, CH2 digital values.............................................W11, W12

CH1, CH2 output monitor values...............................W113, W114

Disconnection detection.............................................W115

Warning output ...........................................................W116

Error code...................................................................W117

Write the intelligent function module parameters to the CPU module.

Perform this operation on the parameter setting module selection screen.