User`s manual

6 - 3 6 - 3
MELSEC-Q
6 PROGRAMMING
6.2.1 Program example using the utility package
(1) Operation of utility package
(a) Initial settings (Refer to Section 5.4)
CH1, CH2 D/A conversion enable/disable setting ...."Enable"
CH1 rate control enable/disable setting....................."Enable"
CH1 increase digital limit value.................................."100"
CH1 decrease digital limit value ................................"30"
CH1 disconnection detection setting ........................."Enable"
CH2 warning output setting........................................"Enable"
CH2 warning output upper limit value........................"10000"
CH2 warning output lower limit value ........................"3000"
(b) Automatic refresh setting (Refer to Section 5.5)
CH1, CH2 digital values.............................................D11, D12
CH1, CH2 output monitor values...............................D13, D14
Disconnection detection.............................................D15
Warning output ...........................................................D16
Error code...................................................................D17