Straight Silencer Installation Manual

2011876H55501
Safety Precautions
Example of installation
Example of installation procedure
The types and levels of danger that may arise if the product is
handled improperly are described with the warning symbols
shown below.
1. Embed commercially available anchor bolts at the
installation positions in advance.
2. Pass the straight silencer through commercially
available suspending bands. Pass the straight silencer
through the anchor bolts, then fix the silencer with
commercially available nuts and washers.
3. Insert the ducts into the duct connecting ports of the
straight silencer, then fix them with commercially
available drill screws at least one for each connecting
point. Apply caulk or tape on the perimeter of the ducts
so that the air will not leak.
Anchor bolt
Suspending bands
Straight silencer
Nut Washer
This silencer is installed in the middle of ducting (between the ventilator and outlet/intake grilles) to reduce noise.
- Be sure to read this manual before starting installation to ensure correct and safe installation.
- Installation must be performed by dealers and qualified professional contractors.
Tape
Duct
Make sure to securely install the product.
Failure to observe this warning may result in the
drop of products and injury.
Always wear gloves during installation.
Failure to observe this warning may result in injury.
Notes before installation
- Do not install this product in kitchen or bathroom,
and use for exhaust from these places. High
humidity and lots of oil smoke may damage the
product.
- Install between grilles and ventilators.
- Make inspection opening below the duct connecting
parts.
Be sure to follow
the instructions.
WARNING
Indicates a risk of death or serious injury.
HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
Straight silencer
MODEL
PZ-100SS-E, PZ-150SS-E, PZ-200SS-E, PZ-250SS-E
Installation Manual For distribution to dealers and contractors
Outside dimensions
Model
PZ-100SS-E
PZ-150SS-E
PZ-200SS-E
PZ-250SS-E
A
450
560
660
660
B
400
500
600
600
C
152
202
252
332
D
99
149
199
249
Weight (kg)
1.9
3.5
5.3
8.9
Connecting duct
φ
100
φ
150
φ
200
φ
250
Unit: mm
A
B
φ
D
φ
C
Inspection opening for straight silencer
(450x450 mm)
Remote controller
Weather cover
Duct Duct
Duct
Ventilator Suspending bands
Grille
Straight silencer
Drill screws
Nut
WARNING
USE TWO NUTS
WARNING
USE DRILL SCREWS
WARNING
SUSPEND AT TWO POINTS
Manual Download
Go to the website below to download manuals,
select model name, then choose language.
http://www.mitsubishielectric.com/
ldg/ibim/