User manual

EN-28
10. Telnet setup (Telnet enabled projectors only)
YoucansetthepasswordforProjectorView,aweb-basedremotecontrolandmonitoringtoolfornetwork
projectors,andtheindustrystandardprotocolPJLinkbasedremoteprojectormanagementtool,thedisplay
languageontheProjectorView,theLANcontrolledmode,andthePJLinkcerticationmodebyrunningTelneton
the projector screen.
Telnet is not available when using other than the projectors listed in page 29. Configure the above settings in
ProjectorView in this case.
<Note>
• Bydefault,TelnetisdisabledonWindowsVistaorWindows7.ToenableTelnet,gotoControlPanelandselect
[ProgramsandFeatures].Intheleftcolumn,select[TurnWindowsfeaturesonoroff]andthencheckthebox
nexttotelnet.
(1) Select the projector that you want to configure on Telnet from the list of projectors on the
main screen.
• RunTelnetononeprojectoratatime.Multipleprojectorscannotbesetsimultaneously.
(2) Click [Telnet] in the toolbar on the main screen.
• Acommandpromptstarts.
• AnerrormessageappearsiftheselectedprojectorisnotTelnetenabled.Ifthishappens,congurethe
projector from ProjectorView.
(3) Press the [Enter] key when the above screen appears.
<Note>
• Pressthe[Enter]keywithinveseconds.Ifnot,theconnectionisterminatedandthe[Enter]keyisnot
recognized.Ifthishappens,exitthecommandpromptandstartitagain.
(4) Setup menus appear.
For more information on telnet, see the LAN Control Utility manual that comes with the projector.