User manual

EN-23
8. ProjectorView
8.3. Entering projector information
(1) Click [SETUP] in the ProjectorView main window (PROJECTOR INFORMATION).
• Setupwindowisdisplayed.
<Note>
• BesuretoenterdatawithinveminutesaftertheSetupwindowisdisplayed.ClickOKtosavechanges.
The connection will turn off in five minutes after the window is displayed so you need to go back to the
mainwindow(PROJECTORINFORMATION)toaccesstheSetupwindow.
(2) Enter data in each field, set Alert e-mail service to ON or OFF, choose Language between
Japanese and English, set PJLink certification setting to ON or OFF, specify Password
setting, and choose to [RESET] Network setting reset.
<Note>
• WhenyouchangetheLanguagesetting,besuretorestarttheProjectorViewforthechangestotakeeffect.
Thefollowingtableexplainseachitem.
Item Description
Projector name Enter a unique name to identity the projector.
Installeddate*
1
Enter the date when the projector is installed.
Installedlocation*
1
Enter the place where the projector is located.
SMTPIPaddress*
2
Enter the IP address of the SMTP server used for sending e-mails.
(e.g.192.168.0.1)
E-mailaddress*
1
Enter the E-mail address to receive alert messages.
   (e.g.[e-mail])(Upto64alphanumericalcharacters)
E-mailfrom*
1
  Enterthesenderofalertmessages.(e.g.[e-mail])
Last lamp replaced date
*1
Enter the date when the last change of lamp was made.
Lastmaintenancedate*
1
Enter the date when the last maintenance was done.
Alert e-mail service Choose whether to send alert messages.
Language  ChoosethedisplaylanguageofProjectorView(JapaneseorEnglish).
PJLinkcerticationsetting ChoosewhethertosetthePJLinkcerticationsetting.
Password setting Click [PASSWORD] to access the network password setting window. (For
details, see “8.4. Setting the network password”.)
Network setting reset Click [RESET] to access the network settings reset window. (For details, see
“8.5. Resetting the network settings”.)
*
1
 Fordataentry,usesingle-bytealphanumericalcharactersandsymbols(+-/=*_!?.,:;#$%&()|<>[]{
}"' @ ).
*
2
For data entry, use single-byte number characters and symbol ( . ).