Service manual

4
● Remote controller
● Operation buttons
Once the controls are set, the same operation mode can be repeated
by simply pressing the ON/OFF button.
FILTER
CHECK MODE
TEST RUN
4
This switches between con-
tinuous operation and the
timer operation.
button
This sets the ventilation fan
speed.
button
button
This sets or switches the cur-
rent time. start time and stop
time.
button
This switches the horizontal
fan motion ON and OFF.
button
Press this button to switch
the cooler electronic dry
(dehumidify) automatic and
heater modes.
button
This resets the filter service
indication display.
FILTER button
This switches between the
operation and stop modes
each time it is pressed. The
lamp on this butoon lights
during operation.
ON/OFF button
This sets the room tempara-
ture The temparature setting
can be performed in 1°C
units
Setting range
Cooler 19°C to 30°C
Heater 17°C to 28°C
TEMP button
This model name of the
remote controller is indicated.
This adjusts the vertical angle
of the ventilation.
(This button dose not operate in
this model)
CHECK-TEST RUN button
Only press this button to per-
form an inspection check or
test operation. Do not use it
for normal operation.