User manual

EN-29
11. Telnet setup (Telnet enabled projectors only)
Youcansetthepassword,ProjectorViewdisplaylanguage,LANcontrol,andPJLinkcerticationbyrunning
Telnet on the projector screen.
Telnet is not available when using other than the projectors listed on page 30.
For more information on Telnet, see the LAN Control Utility manual that comes with the projector.
<Note>
• Bydefault,TelnetisdisabledonWindowsVistaorWindows7.ToenableTelnet,gotoControlPanelandselect
[ProgramsandFeatures].Intheleftcolumn,select[TurnWindowsfeaturesonoroff]andthencheckthebox
nexttotelnet.
11.1. Displaying the Telnet setting screen
(1) Select the projector that you want to configure on Telnet from the list of projectors on the
main screen.
• RunTelnetononeprojectoratatime.Multipleprojectorscannotbesetsimultaneously.
(2) Click [Telnet] in the toolbar on the main screen.
• Acommandpromptstarts.
• AnerrormessageappearsiftheselectedprojectorisnotTelnetenabled.
(3) Press the [Enter] key when the above screen appears.
<Note>
• Pressthe[Enter]keywithinveseconds.Ifnot,theconnectionisterminatedandthe[Enter]keyisnot
recognized.Ifthishappens,exitthecommandpromptandstartitagain.
(4) Setup menus appear.