User manual

EN-16
5. Operation of projector
5.2. Confirmation of projector status
The status of the projector is displayed on the projector list on the main screen.
Item Description
Check Theftdetectorsetting(ON/OFF)
No. Projector list registration number
Projector Name Projector name set in the application
MAC Address MAC address of the projector
IP Address IP address of the projector
Power Powersupplystatusoftheprojector(ON/OFF)
Input Source *
1
 Inputsignaloftheprojector(COMPUTER1/COMPUTER2/VIDEO/S-VIDEO/
HDMI(HDMI1/HDMI2)/DVI-D/SDI/PCLessPresentation/USBDisplay/LAN
Display/COMPONENT)
AVMute Mutestatusoftheprojector(ON/OFF)
Lamp1/2Time(Low) Lampilluminatingtime(HHHH:MM)
In the case of the projector equipped with two lamps, illuminating time for
the lamp 1 is displayed in the left side and illuminating time for the lamp 2 is
displayed in the right side.
Group Name The belonging group of projector
*
1
 HDMIandDVI-DaredisplayedwithDIGITAL1orDIGITAL2byaconnectedprojector.
<Note>
• Thedefaultcycleoftheautomaticre-acquisitionis10minutes.Tochangethiscycle,see“3.1.System
settings.”
• ThestatusofInputSourceandAVMutewillnotbeobtainedunderthefollowingconditions:
- when the projector is powered off
- during warm-up or cool-down.
• Whenmultipleprojectorsareconnected,itmaytaketimetoacquirethestatus.Duringacquiringthestatus,
the status bar at the lower part of the main screen becomes “Getting status...”, and it becomes “Done” when
the acquisition has been completed.