Service Manual

88
OCH636B
<Function setting>
Settings menu
Service menu: MENU
Function setting
Function setting
Cursor Address
Monitor: SELECT
Ref. address
Unit No.
Grp./1/2/3/4/All
F1 F2 F3 F4
Function setting
Cursor Cursor
Request: SELECT
Ref. address
Mode 1
Mode 2
Mode 3
Mode 4
Grp.
Function setting
Cursor Cursor
Request: SELECT
Ref. address
Mode 1
Mode 2
Mode 3
Mode 4
Grp.
2
Set the indoor unit refrigerant addresses and unit numbers with the F1
through F4 buttons, and then press the [SELECT] button to confirm the
current setting.
3
When data collection from the indoor units is completed, the current settings
appears highlighted.
Non-highlighted items indicate that no function settings are made.
Screen appearance varies depending on the "Unit No." setting.
4
Use the F1 or F2 button to move the cursor to select the mode number,
and change the setting number with the F3
or F4 button.
Note: Checking the indoor unit No.
When the [SELECT] button is pressed, the target indoor unit will start
fan operation. If the unit is common or when running all units, all indoor
units for the selected refrigerant address will start fan operation.
Function setting
Ref. address
Sending data
5
When the settings are completed, press the [SELECT] button to send the set-
ting data from the remote controller to the indoor units.
When the transmission is successfully completed, the screen will return to the
Function setting screen.
Note: • Make the above settings only on Mr. Slim units as necessary.
•
The above function settings are not available for the CITY MULTI units.
• Table 1 summarizes the setting options for each mode number. Refer to
the indoor unit Installation Manual for the detailed information about ini
-
tial settings, mode numbers, and setting numbers for the indoor units.
• Be sure to write down the settings for all functions if any of the initial
settings has been changed after the completion of installation work.
Select "Function setting", and press the [SELECT] button.
Select "Setting" from the Service menu, and press the [SELECT] button.
1
Select "Service" from the Main menu, and press the [SELECT] button.
F1 F2 F3 F4
MENU
ON
OFF
RETURN
SELECT
HOLD
F1 F2 F3 F4
MENU
ON
OFF
RETURN
SELECT
HOLD
F1 F2 F3 F4
MENU
ON
OFF
RETURN
SELECT
HOLD
F1 F2 F3 F4
MENU
ON
OFF
RETURN
SELECT
HOLD