Service Manual
29
OCH636B
10-3. HOW TO PROCEED "SELF-DIAGNOSIS"
10-3-1. Self-diagnosis <PAR-4xMAA ("x" represents 0 or later)>
Diagnosis
Cursor
Service menu: MENU
Self check
Remote controller check
F1 F2 F3 F4
kcehc fleS
: SELECTtceleS
Ref. address
sserddA
F1 F2 F3 F4
kcehc fleS
Ref. address
Return: RETURN
teseR
Error Unt # CI.prG
F1 F2 F3 F4
Self check
Return: RETURN
Reset
Ref. address 0
Error Grp.
--
-
Unt#
--
When there is no error history
F1 F2 F3 F4
Self check
Delete error history?
Ref. address
Cancel OK
F1 F2 F3 F4
Self check
Return: RETURN
Ref. address
Error history deleted
2
With the
F1
or
F2
button, enter the refrigerant address, and press the
[SELECT]
button.
3
Check code, unit number, attribute will appear.
"-" will appear if no error history is available.
4
Resetting the error history
Press the
F4
button (Reset) on the screen that shows the error history.
A conrmation screen will appear asking if you want to delete the error history.
Press the
F4
button (OK) to delete the error history.
If deletion fails, "Request rejected" will appear.
"Unit not exist" will appear if no indoor units that are correspond to the entered
address are found.
F1 F2 F3 F4
MENU
ON
OFF
RETURN
SELECT
HOLD
Select "Self check" with the F1 or F2 button,
and press the [SELECT] button.
1
Select "Service" from the Main menu,
and press the [SELECT] button.
Select "Check" from the Service menu,
and press the [SELECT] button.
Select "Diagnosis" from the Check menu,
and press the [SELECT] button.
Navigating through the screens
• To go back to the Service menu .............. [MENU] button
• To return to the previous screen ............... [RETURN] button